This Appendix describes the procedure for PEMS demonstration test at type-approval.
2.1.
The vehicle used for demonstrating the PEMS demonstration test shall be representative for the vehicle category intended for the installation of the engine system. The vehicle may be a prototype vehicle or an adapted production vehicle.
2.2.
The availability and conformity of the ECU data-stream information shall be demonstrated (for example following the provision of Section 5 of Annex II to this Regulation).
The vehicle payload shall be 50-60 % of the maximum vehicle payload in accordance with Annex II.
The test shall be conducted under ambient conditions as described in point 4.2 of Annex II.
3.3.
The engine coolant temperature shall be in accordance with point 4.3 of Annex II.
The fuel, lubricating oil and reagent for the exhaust after-treatment system shall follow the provisions of points 4.4 to 4.4.3 of Annex II.
The trip and operational requirements shall be those described in points 4.5 to 4.6.8 of Annex II.
4.1.
The test shall be conducted and the test results calculated in accordance with Section 6 of Annex II.
5.1.
A technical report describing the PEMS demonstration test shall show the activities and results and give at least the following information:
General information as described in points 10.1.1 to 10.1.1.14 of Annex II.
Explanation as to why the vehicle(s) [Vehicle or vehicles in the case of a secondary engine.’;] used for the test can be considered to be representative for the category of vehicles intended for the engine system.
Information about test equipment and test data as described in points 10.1.3 to 10.1.4.8 of Annex II.
Information about the tested engine as described in points 10.1.5 to 10.1.5.20 of Annex II.
Information about the vehicle used for the test as described in points 10.1.6 to 10.1.6.18 of Annex II.
Information about the route characteristics as described in points 10.1.7 to 10.1.7.7 of Annex II.
Information about instantaneous measured and calculated data as described in points 10.1.8 to 10.1.9.24 of Annex II.
Information about averaged and integrated data as described in points 10.1.10 to 10.1.10.12 of Annex II.
Pass-fail results as described in points 10.1.11 to 10.1.11.13 of Annex II.
Information about test verifications as described in points 10.1.12 to 10.1.12.5 of Annex II.