The producer shall implement a quality management system suitable to demonstrate compliance with the criteria referred to in Articles 3 and 4, respectively.
The quality management system shall include a set of documented procedures concerning each of the following aspects:
acceptance control of waste used as input for the recovery operation as set out in Section 2 of Annexes I and II;
monitoring of the treatment processes and techniques described in Section 3.3 of Annexes I and II;
monitoring of the quality of scrap metal resulting from the recovery operation as set out in Section 1 of Annexes I and II (including sampling and analysis);
effectiveness of the radiation monitoring as set out in Section 1.5 of Annexes I and II, respectively;
feedback from customers concerning compliance with scrap metal quality;
record keeping of the results of monitoring conducted under points (a) to (d);
review and improvement of the quality management system;
training of staff.
The quality management system shall also prescribe the specific monitoring requirements set out in Annexes I and II for each criterion.
Where any of the treatments referred to in Section 3.3 of Annex I or Section 3.3 of Annex II are carried out by a prior holder, the producer shall ensure that the supplier implement a quality management system which complies with the requirements of this Article.
A conformity assessment body, as defined in Regulation (EC) No 765/2008 of the European Parliament and of the Council of 9 July 2008 setting out the requirements for accreditation and market surveillance relating to the marketing of products [OJ L 218, 13.8.2008, p. 30.], which has obtained accreditation in accordance with that Regulation, or any other environmental verifier as defined in Article 2(20)(b) of Regulation (EC) No 1221/2009 of the European Parliament and of the Council of 25 November 2009 on the voluntary participation by organisations in a Community eco-management and audit scheme (EMAS) [OJ L 342, 22.12.2009, p. 1.] shall verify that the quality management system complies with the requirements of this Article. The verification should be carried out every 3 years.
The importer shall require his suppliers to implement a quality management system which complies with the requirements of paragraphs 1, 2 and 3 of this Article and has been verified by an independent external verifier.
The producer shall give competent authorities access to the quality management system upon request.