Estimated values of the vapour pressure can be used:
for deciding which of the experimental methods is appropriate,
for providing an estimate or limit value in cases where the experimental method cannot be applied due to technical reasons.
The vapour pressure of liquids and solids can be estimated by use of the modified Watson correlation (a). The only experimental data required is the normal boiling point. The method is applicable over the pressure range from 105 Pa to 10–5 Pa.
Detailed information on the method is given in ‘Handbook of Chemical Property Estimation Methods’ (b). See also OECD Environmental Monograph No.67 (c).
The vapour pressure is calculated as follows:
ln Pvp ≈ ΔHvbΔZbRTb1 – 3 – 2TTbmTTb– 2m3 – 2TTbm – 1 ln TTb
where:
Ttemperature of interest
Tbnormal boiling point
Pvpvapour pressure at temperature T
ΔHvbheat of vaporisation
ΔZbcompressibility factor (estimated at 0,97)
mempirical factor depending on the physical state at the temperature of interest
Further,
ΔHvbTb = KF (8,75 + R ln Tb)
where, KF is an empirical factor considering the polarity of the substance. For several compound types, KF factors are listed in reference (b).
Quite often, data are available in which a boiling point at reduced pressure is given. In such a case, the vapour pressure is calculated as follows:
ln Pvp ≈ ln P1 + ΔHv1ΔZbRT11 – 3 – 2TT1mT1T – 2m3 – 2TT1m – 1 ln TT1
where, T1 is the boiling point at the reduced pressure P1.
When using the estimation method, the report shall include a comprehensive documentation of the calculation.
Watson, K.M. (1943). Ind. Eng. Chem, 35, 398.
Lyman, W.J., Reehl, W.F., Rosenblatt, D.H. (1982). Handbook of Chemical Property Estimation Methods, McGraw-Hill.
OECD Environmental Monograph No.67. Application of Structure-Activity Relationships to the Estimation of Properties Important in Exposure Assessment (1993).