ANNEX VIII OPERATIONAL REQUIREMENTS FOR VESSELS, Decision_act (EU) 2005/938

In force
1.

For the purposes of this Annex:

(a)

‘strip’ means a section of net that is approximately 6 fathoms deep;

(b)

‘backdown’ means the procedure for releasing captured dolphins by shifting the vessel's engine(s) into reverse during net retrieval, causing the net remaining in the water to form a channel, and the corkline at the apex of the channel to submerge;

(c)

‘bunch’ means a length of corkline gathered together;

(d)

‘sack-up’ means that part of the fishing process when the catch is concentrated near the surface for loading aboard the vessel.

2.

Dolphin safety gear and equipment requirements

A vessel with a carrying capacity of more than 363 metric tonnes (400 short tonnes) operating in the Agreement Area shall:

(a)

have a purse seine equipped with a dolphin safety panel (DSP) with the following characteristics:

(i)

a minimum length of 180 fathoms (as measured before installation), except that the minimum length of the DSP in nets deeper than 18 strips must be determined in a ratio of 10 fathoms in length for each strip of net depth. The DSP must be installed so as to cover the backdown channel along the corkline, beginning at the outboard end of the last bow bunch pulled and continuing to at least two-thirds the distance from the apex of the backdown channel to the point where the net is secured at the stern. The DSP shall consist of small-mesh webbing not to exceed 1 1/4 inches (3,2 cm) stretched mesh, extending downward from the corkline to a minimum depth of two strips;

(ii)

each end shall be identified with a highly visible marker;

(iii)

any space between the corks or the corkline and the small mesh shall not exceed 1 3/8 inches (3,5 cm) in diameter;

(i)

a minimum length of 180 fathoms (as measured before installation), except that the minimum length of the DSP in nets deeper than 18 strips must be determined in a ratio of 10 fathoms in length for each strip of net depth. The DSP must be installed so as to cover the backdown channel along the corkline, beginning at the outboard end of the last bow bunch pulled and continuing to at least two-thirds the distance from the apex of the backdown channel to the point where the net is secured at the stern. The DSP shall consist of small-mesh webbing not to exceed 1 1/4 inches (3,2 cm) stretched mesh, extending downward from the corkline to a minimum depth of two strips;

(ii)

each end shall be identified with a highly visible marker;

(iii)

any space between the corks or the corkline and the small mesh shall not exceed 1 3/8 inches (3,5 cm) in diameter;

(b)

have at least three operable speedboats equipped with operable towing bridles or posts, and tow lines;

(c)

have an operable raft suitable for the observation and rescue of dolphins;

(d)

have at least two operable facemasks suitable for underwater observation; and

(e)

have an operable long-range floodlight with a minimum output of 140 000 lumens.

3.

Dolphin protection and release requirements and prohibitions A vessel with a carrying capacity of more than 363 metric tonnes (400 short tonnes) operating in the Agreement Area shall:

(a)

perform backdown during every set in which dolphins are captured, until it is no longer possible to remove live dolphins from the net by this procedure. At least one crewman shall be deployed during backdown to aid in the release of dolphins;

(b)

continue efforts to release any live dolphins remaining in the net after backdown, so that all live dolphins are released prior to the initiation of the sack-up procedure;

(c)

not sack-up or brail live dolphins;

(d)

avoid injuring or killing dolphins captured in the course of fishing operations;

(e)

complete backdown no later than 30 minutes after sunset, as determined by an accurate and reliable source approved by the Parties. A set that does not meet this requirement is termed a ‘night set’;

(f)

not use any type of explosive during any phase of a fishing operation involving dolphins (underwater flares are not considered to be explosives);

(g)

cease setting on dolphins when its DML has been reached;

(h)

not intentionally set on dolphins if the vessel does not have a DML; and

(i)

perform a periodic net alignment to ensure the proper location of the dolphin safety panel during the backdown procedure, based on criteria established by the IRP.

It is emphasised that the above requirements should not lead to crewmen being placed in situations that present unnecessary risks to their personal safety.

4.

Exceptions

(a)

A vessel without a DML is exempt from the requirements of paragraph 2 of this Annex and from the obligation of carrying out the backdown manoeuvre mentioned in paragraph 3 of this Annex unless the Party with jurisdiction over that vessel determines otherwise.

(b)

Any such vessel that captures dolphins accidentally shall attempt to release the dolphins, using every means at its disposal, including aborting the set, and taking into consideration the requirements set forth in paragraph 3 of this Annex.

5.

Treatment of observers

Captains, crew, and other personnel shall comply with their responsibilities regarding the presence of observers aboard their vessels, as specified in Annex II, paragraph 6.

6.

Vessels under 363 metric tonnes (400 short tonnes)

No vessel with a carrying capacity of 363 metric tonnes (400 short tonnes) or less may intentionally set on dolphins.