Art. 5 Directive (EU) 1993/68

In forcesince 12 Aug 1998

Directive 89/336/EEC is hereby amended as follows:

1.

throughout the text, the term ‘EC mark’ is replaced by ‘CE marking’;

2.

Article 3 is replaced by the following text:

‘Article 3

Member States shall take all appropriate measures to ensure that the apparatus referred to in Article 2 may be placed on the market or taken into service only if it bears the CE marking provided for in Article 10 indicating its conformity to all the provisions of this Directive, including the conformity assessment procedures laid down in Article 10, when it is properly installed and maintained and when it is used for the purposes for which it is intended.’

;

3.

the following fifth subparagraph is added to Article 10 (1):

‘Member States shall take the necessary measures to prohibit the affixing to apparatus, its packaging, the instructions for use and the guarantee certificate of markings which are likely to deceive third parties as to the meaning and form of the CE marking. Any other marking may be affixed to the apparatus, its packaging, the instructions for use or the guarantee certificate provided that the visibility and legibility of the CE marking is not thereby reduced.’

;

4.

in Article 10 (6) the first subparagraph is replaced by the following text:

‘6. Member States shall notify the Commission and the other Member States of the competent authorities referred to in this Article and the bodies responsible for issuing the EC type-examination certificates referred to in paragraph 5, together with the specific tasks which these bodies have been appointed to carry out and the identification numbers assigned to them beforehand by the Commission.

The Commission shall publish in the Official Journal of the European Communities a list of the notified authorities and bodies with their identification numbers and the tasks for which they have been notified. The Commission shall ensure that this list is kept up to date.’

;

5.

the following paragraph is added to Article 10:

‘7. Without prejudice to Article 9:

(a)

where a Member State or a competent authority establishes that the CE marking has been affixed unduly, the manufacturer or his authorized representative established within the Community shall be obliged to make the product comply as regards the provisions concerning the CE marking and to end the infringement under conditions imposed by the Member State;

(b)

where non-compliance continues, the Member State must take all appropriate measures to restrict or prohibit the placing on the market of the product in question or to ensure that it is withdrawn from the market in accordance with the procedures laid down in Article 9.’

;

6.

Annex I section 2 is replaced by the following text:

‘2. CE conformity marking

–

The CE conformity marking shall consist of the initials “CE” taking the following form:

–

If the CE marking is reduced or enlarged the proportions given in the above graduated drawing must be respected.

–

Where apparatus is the subject of other Directives covering other aspects and which also provide for the CE conformity marking, the latter shall indicate that the appliances are also presumed to conform to those other Directives.

–

However, where one or more of these Directives allow the manufacturer, during a transitional period, to choose which arrangements to apply, the CE marking shall indicate conformity only to the Directives applied by the manufacturer. In this case, particulars of the Directives applied, as published in the Official Journal of the European Communities , must be given in the documents, notices or instructions required by the Directives and accompanying such apparatus.

–

The various components of the CE marking must have substantially the same vertical dimension, which may not be less than 5 mm.’

—————