, Agreement between the European Union and Japan for an Economic Partnership

In forcesince 1 Feb 2021
1.

For the purpose of satisfying the product specific rule of origin of Column 2 in Annex 3-B applicable to motor vehicles of subheadings 8703.21 to 8703.90, a material listed in Column (i) in the table below used in the production of those motor vehicles shall be considered originating in a Party if:

(a)

it meets the product specific rule of origin of Column 2 in Annex 3-B applicable to that material; or

(b)

the production process related to that material, as laid down in Column (ii) in the table below, is carried out in a Party.

Table

[Where a specific description of a material is included in Column (i), the related production process in Column (ii) applies only to that material.] [For the purposes of this Section, ‘bodies in white’ means bodies where the metal components have been joined together before painting; including assembly of: frame; and body parts; and excluding assembly in the frame structure of: the engine; the chassis sub-assemblies, or trim (glass, seats, upholstery, electronics, etc.); or moving parts (doors, trunk, bonnet, as well as fenders).] [In order to apply the related production process rule: (a) the parts of the body in white listed below, to the extent they are constituent parts of the body in white, shall be made in steel: A, B and C pillars or equivalent part; side members or equivalent part; cross members or equivalent part; floor side rails or equivalent part; sides panels or equivalent part; roof side rails or equivalent part; dash board support or equivalent part; roof supports or equivalent part; rear wall or equivalent part; firewall or equivalent part; bumper beams or equivalent part; and floor pan or equivalent part; and (b) parts or combinations of parts, whichever their name, as far as they fulfil the same function as the parts listed above, shall also be made in steel.]

Column (i)

Harmonized System Classification (2017) including specific description

Column (ii)

Related production process

7007.11 | Tempering of a non-originating material provided that non-originating materials of heading 70.07 are not used.

7007.21 | Tempering or laminating of a non-originating material provided that non-originating materials of heading 70.07 are not used.

8707.10 |

–

Bodies in white in steel, for the motor vehicles of subheadings 8703.21 to 8703.90

Production from non-originating semi-finished steel products of headings 72.07, 72.18 and 72.24.

8708.10 |

–

Bumpers (not including parts thereof)

All non-originating polymer and flat-rolled products used shall be moulded or stamped.

8708.29 |

–

Body stampings (not including parts thereof)

All non-originating materials shall be moulded or stamped.

–

Door assemblies (not including parts thereof)

All non-originating materials used to produce door skin or insole panel shall be moulded or stamped; and

all non-originating door parts used shall be assembled; and

non-originating materials of heading 87.08 shall not be used.

8708.50 |

–

Drive-axles with differential, whether or not provided with other transmission components

Drive shaft and differential gears are produced from non-originating flat-rolled metal; and

non-originating materials of heading 87.08 shall not be used.

–

Non-driving axles (not including parts thereof)

Non-driving axles are produced from non-originating flat-rolled metal; and

non-originating materials of heading 87.08 shall not be used.

2.

The application of paragraph 1 is without prejudice to the application of the provisions of Section A of Chapter 3 and Annex 3-A.