>PIC FILE= "L_2002245EN.048602.TIF">
505-1
Part below 130 mm on vehicles which must not pass over shunting humps or negotiate rail brakes and other activated shunting and stopping devices
>PIC FILE= "L_2002245EN.048701.TIF">
Certain gauge restrictions must be observed at right angles to the axles when vehicles are placed on an under-floor lathe for wheel reprofiling.
zone for equipment awqay from wheels
zone for equipment in immeditate proximity of wheels
zone for contact ramp brushes
zone for wheels and other parts coming into contact with the rails
zone occupied exclusively by the wheels
Limit for parts located outside the axle ends (guard irons, sanders, etc.) not to be exceeded for running over detonators. This limit may however be disregarded for parts located between the wheels, provided these parts remain within the wheel track.
Maximum theoretical width of the flange profile in the case of check-rails
Effective limit position of the outside surface of the wheel and of the parts associated with this wheel
When the vehicle is in any position whatsoever on a curve of radius R = 250 m (minimum radius for contact rampo installation) and a track width of 1465 mm, no part of the vehicle likely to descend to less than 100 mm from the running surface, except for the contact brush, should be less than 125 mm from the track centre.
For parts located inside the bogles, this dimension is 150 mm.
Effective limit position of the internal surface of the wheel when the axle is against the opposite rail. This dimension varies with gauge widening.
GA, GB AND GC, KINEMATIC GAUGES
Reference profiles
>PIC FILE= "L_2002245EN.048801.TIF">
N.B.:
Up to a height of 3250 mm, the reference profile of GA, GB and GC gauges is identical.
LOWER PARTS
A. Lines over which powered units used on international services run
>PIC FILE= "L_2002245EN.048901.TIF">
B. Lines over which coaches, vans and wagons used on inernational services run (with the exception of powered units used on international services)
>PIC FILE= "L_2002245EN.048902.TIF">
Note:
On inclined connections with a radius R >= 500 m, the vertical measurements shown in diagrams A and B above mut be reduced by
>REFERENCE TO A GRAPHIC>
(R in m. If 625 >= R >= 500 m, the measurement 80 in diagram A is cancelled.
KINEMATIV GAUGE FOR THE LOWER PARTS IN THE AREA OF THE RAIL, THE AREA TAKEN UP BY TRACK BRAKES AND THE AREA OF THE CENTRE LINE OF THE TRACK
A. Lines over which powered units used on international services run
>PIC FILE= "L_2002245EN.049001.TIF">
KINEMATIC GAUGE FOR THE LOWER PARTS
B. Lines over which coaches, vans and wagons used on international services run, excluding powered units
>PIC FILE= "L_2002245EN.049101.TIF">
l = width of track.
On concave or convex inclined connections with a radius R >= 500 m, this dimension must be reduced by
>REFERENCE TO A GRAPHIC>