3.1. Article 4 of Title II of this Appendix, concerning products having obtained originating status which are used 2.1. The first two columns in the manufacture of other products, shall apply, regardless of whether that status has been obtained inside the factory where those products arelist describe the product obtained. The column (1) gives the heading number or chapter number used or in another factory in a Party.
3.2. Pursuant to Article 6 of Title II of this Appendix, the working or processing carried out must go beyond the list of operations mentionedin the Harmonised System and the column (2) gives the description of goods used in that Article. If it does not, the goods shall not qualify for the granting of the benefit of preferential tariff treatment, even if the conditions set out in the list below are met.
Subject to Article 6 of Title II of this Appendix, the rules in the list represent the minimum amount of working or processing required, and the carrying-out of more working or processing also confers originating status; conversely, the carrying-out of less working or processing cannot confer originating status.
Thus, if a rule provides system for that heading or chapter. For each entry in the first two columns, a rule is specified in column (3). Where, in some cases, the entry in the column (1) is preceded by an ‘ex’, this signifies that non-originating material, at a certain level of manufacture, may be used, the use of such material at an earlier stage of manufacture is allowed, and the use of such material at a later stage is not.
If a rule provides that non-originating material, at a certain level of manufacture, may not be used, the use of materials at an earlier stage of manufacture is allowed,the rules in column (3) apply only to the part of that heading as described in column (2).
2.2. Where several heading numbers are grouped together in column (1) or a chapter number is given and the use of materials at a later stage is not.
Example: when the list-rule for Chapter 19 requires that ‘non-originating materials of headings 1101 to 1108 cannot exceed 20 % weight’, the use (i.e. importation) of cereals of Chapter 10 (materials at an earlier stage of manufacture) is not limited.
3.3. Without prejudice to Note 3.2, where a rule uses the expression ‘Manufacture from materials of any heading’, then materials of any heading(s) (even materials of the same description and heading as the product) may be used, subject, however, to any specific limitations description of products in column (2) is therefore given in general terms, the adjacent rules in column (3) apply to all products which may also be contained in the rule.
However, the expression ‘Manufacture from materials of any heading, including other materials of heading …’ or ‘Manufacture from materials of any heading, including other materials of the same heading as the product’ means that materials of any heading(s) may be used, except those , under the Harmonised System, are classified in headings of the chapter or in any of the same description as the product as given headings grouped together in column (2) of the list.
3.4. When a rule 1).
2.3. Where there are different rules in the list specifies that a product may be manufactured from more than one material, this means that one or more materials may be used. It does not require that all be used.
3.5. Where a rule in the list specifiesapplying to different products within a heading, each indent contains the description of that a product must be manufactured from a particular material, the condition does not prevent the use of other materials which, because of their inherent nature, cannot satisfy this.
3.6part of the heading covered by the adjacent rules in column (3).
2.4. Where, in a rule in the list, two percentages are given for the maximum value of non-originating materials that can be used, then those percentages may not be added together. In other words, the maximum value of all the non-originating materials used may never exceed the higher two alternative rules are set out in column (3), separated by ‘or’, it is at the choice of the percentages given. Furthermore, the individual percentages shall not be exceeded, in relation to the particular materials to which they applyexporter which one to use.