3.2.1. The U.S. Technical Agent shall carry out the State of Design functions applicable to the United States under Annex 8 of the Convention on International Civil Aviation done at Chicago on 7 December 1944 (the Chicago Convention) for regulated entities over which it has jurisdiction.
3.2.2. The EC Technical Agent shall carry out on behalf of the EU Member States the State of Design functions applicable to them under Annex 8 of the Chicago Convention for regulated entities over which it has jurisdiction.
3.2.3. To benefit from reciprocal acceptance under this Agreement:
EASA shall act as the certificating authority and accept certification applications only from applicants located within the territory of the European Community for the initial approval of their design, design changes and repair data; and
FAA shall act as the certificating authority and accept certification applications only from applicants located within the United States for the initial approval of their designs, design changes and repair data.
3.2.4. Each Technical Agent shall use a validation process to approve:
the design of aircraft, aircraft engines, propellers and appliances;
supplemental type certificates;
certain major changes to type design, as defined in the technical implementation procedures; and
acoustical and emission changes,
that have been, or are in the process of being, approved by the other Party’s Technical Agent in carrying out the State of Design’s functions. The validation process, as defined in the technical implementation procedures, shall be based to the maximum extent practicable on the technical evaluations, tests, inspections, and compliance certifications made by the other Technical Agent. The airworthiness certification basis developed during the validation process of an aircraft, aircraft engine, or propeller shall use the applicable airworthiness standards or codes in effect on the date of application to the Technical Agent carrying out the State of Design functions. The environmental certification basis shall be developed based on the application dates prescribed in the technical implementation procedures.
3.2.5. The Technical Agents shall ensure that information related to operational requirements that impact design is made available to each other during the validation process. The Aviation Authorities shall make such information available to EASA.
3.2.6. The Technical Agents may also use a joint certification process, where appropriate. Joint certification is an alternative form of validation when mutually agreed by the applicant and both Technical Agents, as defined in the technical implementation procedures. Joint certification is particularly appropriate when components of a new product are designed by a regulated entity located within the territory of the other Party. Under joint certification, compliance demonstration and findings are expected to be made locally by the other Party’s Technical Agent.
3.2.7. Because the Parties’ regulatory systems for parts, repair design data, and design changes other than those covered by 3.2.4, are considered sufficiently comparable such that a separate approval by the importing Party’s Technical Agent or Aviation Authority is not required, the importing Technical Agent shall accept a part, repair design data or design change when it has already been approved or otherwise accepted by the other Party’s Technical Agent in carrying out the State of Design functions for the part, repair design data, or design change. The technical implementation procedures shall identify when a separate approval by the importing Technical Agent is necessary.
3.2.8. Certifying statements related to design approvals, including information on noise and emission levels, shall be defined in the technical implementation procedures.
3.2.9. In the event that a design approval holder transfers its approval to another entity, the Technical Agent responsible for the design approval shall promptly notify the other Technical Agent of the transfer. The Technical Agents shall define procedures to facilitate the transfer of certificates between the Parties’ regulated entities in the technical implementation procedures.
3.2.10. EASA shall accept the U.S. certification procedures as an acceptable alternative to the European Community’s requirements for demonstrating the capability of an applicant.